- 偏移电压, 补偿电压
- 失调电压
- offset: n. 1.抵销，抵销物，(优点对缺点等的)弥补，补偿 ( ...
- voltage: n. 【电学】电压，电压量，伏特数。 the worki ...
- drift input offset voltage: 输入偏移电压漂移
- equivalent input offset voltage: 等值输入抵销电压
- forward offset voltage: 正向低偿电压
下载手机词典可随时随地查词查翻译
offset voltage中文什么意思
- 偏移电压, 补偿电压
- 失调电压
下载手机词典可随时随地查词查翻译
例句与用法
- 更多例句： 下一页
- Input offset voltage
输入失调电压 - Second , since input bias currents are not always small and can exhibit different polarities , source impedance levels should be carefully matched to minimize additional input bias current - induced offset voltages and increased distortion
其次,因为输入偏置电流不一定都小,且可能体现不同的极性，而且源阻抗水平应该仔细地进行匹配，以将输入偏置电流引起额外失调电压和增加的畸变减到最小。 - 3 . a good result is gotten under the star - hspice simulation . the dc gain is 90 db , the offset voltage is 40 u v while driving 10k , the unity - gain frequency is 10mhz with phase margin 67 , the slew rate is 10w us while driving 10pf
用star - hspice仿真软件对电路仿真，在1 . 5v电源电压、直流10k负载、交流10pf负载的情况下，整个共模电压范围内跨导基本保持恒定，只有18的变化，直流增益90db ，单位增益带宽10mhz ，相位裕度80度，压摆率10v s 。 - In order to do the research works above better , we must can precisely control the width of the quasi - 1d channel and the cut off point , and also must precisely inspire current in the 2deg , so we designed the 2 channel high precision and high stability voltage source , one channel can supply the minus voltage to the split - gate , and the other one can supply the offset voltage between the source and drain pole
为了进行上述研究,必须能够精确的控制准一维电子通道的宽度和钳断,以及精确的在2deg上激励电流,由此我们设计研发了给分裂门加负偏压和给准一维电子通道加源漏偏压的两路高精度高稳定性馈源。 - Second , the results of theory analysis and simulation research show that the output of one cycle controlled bridge switching power amplifier have dc offset because of the nonideal characteristic of reset signal . the magnitude of output dc offset voltage is proportional to width of reset pulse . a voltage compensation technique is used to solve this question , and the computation formula of compensation voltage is gived . the circuit compensated and not are researched through simulation and experiment , which results show that compensated circuit solve the output dc offset effectively
其次，理论分析和仿真研究结果表明，由于复位脉冲的非理想特性，单周控制的全桥开关功率放大器输出端存在直流偏置问题，其大小与复位脉冲的宽度成正比。针对输出直流偏置问题，提出了电压补偿的改进方案，给出了补偿电压的具体计算公式。对补偿前和补偿后的方案进行了对比仿真研究和实验研究。